A useful accessory to the Premium Range
of Cruise Controls - AP300 and AP500

Installation Connections for the CM8

Position the CM8 on the dashboard, so that is easy to see and operate.

Feed the three wires of the CM8 through the dashboard.

Place the pins into the supplied 3 pole connector matching the colours - blue, black
and orange to the colour coded label.

Connect the 3 pole connector to the cruise controls wiring loom.

Set-up procedure
The CM8 can be set up to store memory functions as follows:

Drive at the desired speed and set that speed on the cruise control.

Hold the first memory button until an audible beep signal is emitted
(approx 6 seconds).

Repeat the above with the two remaining memory buttons, driving at the other
two desired speeds.

Operation of the CM8

The CM8 can be activated either while using your cruise control or while the cruise
control is in standby mode.

Press the memory button corresponding to the desired speed and the CM8 sets the
cruise control at that pre-selected speed. Your current speed needs to be within 50%
of the pre-selected, e.g. 20 mph for a 40 mph memory setting.